1 - 6 Operator’s Manual
1 Safety Precautions
• To dispose of the system or any part, contact Mindray Customer Service Department or sales
representative. Mindray is not responsible for any system content or accessories that have been
discarded improperly.
• Electrical and mechanical performance may be degraded due to long usage (such as current
leakage or distortion and abrasion); the image sensitivity and precision may become worse too.
To ensure optimal system operations, it is recommended that you maintain the system under a
Mindray service agreement.
• Refer replacing job to Mindray service engineers or engineers authorized by Mindray only.
• Do not turn OFF the power supply of the system during printing, file storage or invoking other
system operations. An interrupted process may not be completed, and can become lost or
corrupted.
• Ensure that the current exam date and time are the same as the system date and time.
• Use detachable power supply cord as mains power breaking device. DO NOT set equipment in
place where difficult for disconnection of detachable power supply cord.
Please read the following precautions carefully to ensure the safety of the patient and the operator
when using the probes.
• The ultrasound probe is only for use with the specified ultrasound
diagnostic system.
• The ultrasound probe must be used only by qualified professionals.
• Confirm that the transducer and probe cable are normal before and after
each examination. A defective probe may cause electric shock to the
patient.
• Do not subject the probe to shock. A defective probe may cause electric
shock to the patient.
• Do not disassemble the probe to avoid the possibility of electric shock.
• Never immerse the probe connector into liquids such as water or
disinfectant because the connector is not waterproof. Immersion may
cause electric shock or malfunction.
• A transducer sheath must be installed over the transducer before
performing examination.
• When using a probe, pay attention to the status of the ultrasound image.
Do not use the probe to perform image acquisition when the image is
frozen.
• When using the probe, wear sterile gloves to prevent infection.
• Be sure to use sterile ultrasound gel. Please use the ultrasound gel com-
pliant with the relevant local regulations. And manage the ultrasound gel
properly to ensure that it does not become a source of infection.
To Next Page
Loading...
Need help?
General
