2 - 14 Operator’s Manual
2 System Overview
• Add: tap [Add] to enter the Adding New Command menu, tap [Function Description] to select
the desired function, enter the user-defined command in the [Command] text box, and then
select OK.
User-defined command naming rules: only Chinese characters, English letters, and digits are
supported; the English letters are case-insensitive, consecutive blank spaces are not supported,
and a maximum of 128 letters are allowed when entering the English letters; Blank spaces are
not supported and a maximum of 30 characters are allowed when entering the Chinese
characters; the user-defined commands cannot be empty; User defined commands that are
already exited in the system but represent different functions are not supported to be added.
• Test: Tap [Test] and input a vocal command to the microphone device. After the vocal
command is recognized, the Success Rate is displayed in fraction. Tap [Test] again to close the
vocal command test.
If the vocal command is successfully recognized by the system, both the denominator and
numerator of the Success Rate are added by 1 for each time; if the vocal command fails to be
recognized by the system, the denominator of the Success Rate is added by 1 for each time
through tapping the icon, while the numerator remains the same. For example: 2/3
represents 2 times of success and 1 time of failure.
• Clear: Tap [Clear] to clear all the Success Rate test records.
To Next Page
Loading...
Need help?
General
