Mindray V Series User Manual

V Series Operating Instructions 6 - 3
Patient Management Patient Info Dialog
6.2.2 Admitting a Patient
NOTE: When connected to a central monitoring system (i.e., central station), a
patient admission at the V 12/V 21 bedside monitor also admits the
patient to the central station. Refer to the central station operating
instructions for additional information.
1. Turn the monitor on using the ON/OFF switch located on the lower right of the monitor.
NOTE: Refer to "V 12/V 21 Physical Views" on page 1-4 for additional
information and location of ON/OFF switch.
NOTE: Remove the previous patient’s data by discharging the patient before
admitting the new patient. Refer to "Discharging a Patient" on page 6-6
for additional information.
2. Connect the patient to the monitor and apply the appropriate accessories such as ECG
electrodes, blood pressure cuff, etc.
6.2.3 Patient Demographics
To enter or edit patient information after admission in the Demographics tab.
1. Select the Header Bar (located above the top waveform) to display the Patient Info dialog.
By default, the Demographics tab is selected.
2. Select the applicable button to begin entering or editing. Refer to TABLE 6-1 for a description of
each button.
NOTE: Refer to the Chapter 2.0 Getting Started section for specific instructions
on how to use the keyboards, keypads, etc.
NOTE: When connected to a central monitoring system (i.e., central station),
the following fields are updated at the central station whenever they
are entered or edited at the V 12/V 21 beside monitor: Patient Size, ID,
Bed, Year, Month, Day (date of birth), Gender, and Height. Refer to the
central station operating instructions for additional information.
TABLE 6-1
BUTTON SELECTIONS COMMENTS
Patient Size Adult
Pediatric
Neonate
Select to enter the patient size.
Verify monitoring settings when the patient size is changed.
NOTE: The selected patient size remains after power down and discharge.
NOTE: A confirmation dialog displays if you change patient size. Verify
monitoring settings when the patient size is changed.
ID None Select to enter or change Patient ID.
Accepts up to 15 alphanumeric characters.
Factory default is a blank value.
Last Name None Select to enter or change patient’s last name.
Accepts up to 15 alphabetic characters.
Factory default is a blank value.
First Name None Select to enter or change patient’s first name.
Accepts up to 15 alphabetic characters.
Factory default is a blank value.
* Default values display in bold.

Mindray V Series Specifications

General

Brand	Mindray
Model	V Series
Category	Medical Equipment
Language	English