Patient Info Dialog Patient Management
6 - 6 V Series Operating Instructions
6.2.5 Discharging a Patient
Discontinue monitoring a patient by discharging them from the monitor. Discharging a patient clears
all their historical data from the monitor.
NOTE: When connected to a central monitoring system (i.e., central station), a
patient’s discharge from the V 12/V 21 bedside monitor also discharges
the patient from the central station. Refer to the central station
operating instructions for additional information.
NOTE: Switching leadsets or discharging a patient automatically reverts the
ST Dialog Representative Beat Display setting to the default of Auto.
NOTE: Do not turn off the V 12/V 21 before discharging is complete.
1. Select the Header Bar (located above the top waveform).
The Patient Info dialog displays.
2. Select the Transfer/Discharge tab (as shown in FIGURE 6-4).
FIGURE 6-4 Example Patient Info (Transfer/Discharge Tab)
3. Select Discharge. A confirmation dialog displays the message Are you sure you want to
discharge? This will restore the defaults for all settings and clear history data.
4. Select No or Yes.
• Selecting No cancels the operation.
• Selecting Ye s does the following:
•Returns to the Discharge dialog
•Discharge occurs at the local monitor and the central station (if applicable).
•All patient data and trends are cleared.
•Default departmental settings are restored.
To Next Page
Loading...
