Mindray V Series - Configuring Resp Alarm Limits; Configuring the Resp Parameter; Resp Dialog

V Series Operating Instructions 10 - 3
Respiration (Resp) Resp Dialog
FIGURE 10-1 Example Resp Dialog (Alarms Tab)
10.2.2 Configuring Resp Alarm Limits
Refer to "Configuring Alarm Limits" on page 8-2 for additional information.
10.2.3 Configuring the Resp Parameter
1. Select the Resp digital or waveform tile.
2. Select the Setup tab (as shown in FIGURE 10-2).
NOTE: The current parameter setting displays in bold to the right of the each
button.