Mindray V Series - Configuring ST Alarms Limits; Configuring the ST Parameter

V Series Operating Instructions 16 - 3
ST ST Dialog
FIGURE 16-1 Example ST Dialog (Alarms Tab)
16.2.2 Configuring ST Alarms Limits
Refer to "Configuring Alarm Limits" on page 8-2 for additional information.
16.2.3 Configuring the ST Parameter
1. Select the ST tile.
2. Select the Setup tab (as shown in FIGURE 16-2).
NOTE: The current parameter setting displays in bold to the right of the each
button.