Mindray V Series - Alarm Responses: Cco;Hemo Tab; Configuring the CCO Parameter

CCO/Hemo Configuration Continuous Cardiac Output (CCO) & Continuous Hemodynamics (Optional)
1 - 6 Addendum to V Series Operating Instructions
1.2.3 Alarm Responses: CCO/Hemo Tab
To display the alarm responses for the CCO/Hemo tab:
1. Select the Alarms tab from the Navigation Area.
2. Select the Responses button.
3. Select the CCO/Hemo tab.
TABLE 1-2 contains the alarm responses for the CCO/Hemo parameter.
1.2.4 Configuring the CCO Parameter
1. Select the Setup tab from the Navigation Area.
2. Select the Parameters button, then select the CCO button.
or
Select the CCO digital tile.
3. Select the Setup tab (as shown in FIGURE 1-4).
NOTE: The current parameter setting displays in bold to the right of each
button.
TABLE 1-2
ALARM LEVELS*
FACTORY
DEF
AULT ALARM RESPONSES
ALARM LEVELS
BUTTO
N HIGH MEDIUM LOW
PRINT ON
ALARM
SAVE TO
EVENT
NURSE
CALL
CCO/CCI X X X Off On Off
SVR/SVRI X X X Off On Off
RVEF/EDV/EDVI/SV/SVI — X X Off On Off
SvO2 X X X Off On Off
* X indicates available alarm level, — in
dic
ates alarm level not available
** The factory default configuration settings are in bold.