Minebea Intec PR5900 - Page 136

Weighing point C @admin
Weighing point
Interface
Baudrate
Data bits
Parity
Stop bits
xBPI scale
Built-in RS-485
9600 baud
8 data bits
odd parity
1 stop bit
Default Save
Inactive parameters are grayed out.
[Interface]
Serial interfaces.
Selection: not assigned, Built-in RS-232, Built-in RS-485,Option‑x RS-485‑A,
Option‑x RS-485‑B
Note:
If a remote terminal is connected to Maxxis, the RS-485 interface of the remote
terminal can also be selected.
[Baud rate]
Baud rate of the data transfer.
Note:
The selected value must match the value of the connected device.
Selection: [9600], 19200, 38400 baud
[Stop bits]
Units for transmission protocols.
Selection: 1 stop bit, [2 stop bits]
[Default] soft key
Settings are reset to factory settings.
4.7.5.2 Parameters
In this menu item, the parameters of the xBPI scale weighing electronics are congured.
The following parameters must be congured:
- [Tare timeout], timeout for tare function depending on the application
- [SBN address], the SBN address of each xBPI scale in bus operation
2. Select and conrm the individual parameters.
3. Press the [Save] soft key to save the settings.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-134