Minebea Intec PR5900 - Page 146

WP-C R1 Max 30kg d= 0.0005kg
000001
–
xBPI scale setup @admin
Calibration check
input
input
Load to small
-10.0000 kg
-0.00010 kg
Accept Reset error Cancel
WP-C R1 Max 30kg d= 0.0005kg
50000
+
xBPI scale setup @admin
Calibration check
input
input
Difference display
0.0005 kg
10.00030 kg
Accept Reset error Cancel
WP-C R1 Max 30kg d= 0.0005kg
000001
+
kg
xBPI scale setup @admin
Calibration check
NET
input
Done
10.0000 kg
10.00015 kg
Accept Reset error Cancel
4.7.5.3.6 Adjust with internal weight
In this menu item, the xBPI scale weighing electronics are calibrated with an internal
weight.
2. Place the weight on the scale.
The deviation is shown. Weight + deviation with 10-fold resolution in the last line.
3. Press the [Accept] soft key.
The data is transferred and the calibration check indicates [complete]. The weight
is shown. With 10-fold resolution in the last line.
4. Remove the weight.
5. Press the EXIT key to return to the xBPI setup menu.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-144