Minebea Intec PR5900 - Page 150

WP-C R1 Max 30kg d= 0.0005kg
000001
–
xBPI scale setup @admin
Calibration check
input
input
Load to small
-10.0000 kg
0.00020 kg
Accept Reset error Cancel
WP-C R1 Max 30kg d= 0.0005kg
02000
+
xBPI scale setup @admin
Calibration check
input
input
Difference display
0.0020 kg
10.00180 kg
Accept Reset error Cancel
WP-C R1 Max 30kg d= 0.0005kg
000002
–
xBPI scale setup @admin
Calibration check
input
input
Load to small
-20.0000 kg
0.00020 kg
Accept Reset error Cancel
4. Place the displayed weight (here 10 kg) on the scale.
The deviation is shown. Weight + deviation with 10-fold resolution in the last line.
5. Press the [Accept] soft key.
The third linearization point to be calibrated is displayed.
6. Place the displayed weight (here 20 kg) on the scale.
The deviation is shown. Weight + deviation with 10-fold resolution in the last line.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-148