Minebea Intec PR5900 - Page 153

WP-C Max 29.9kg d= 0.0005kg
00000
kg
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
xBPI scale
Liquid counter
Parameters Calib Units Setup
Possible error message:
"Retrieve failed – timeout in communication"
This message is displayed if communication with the xBPI scale is not possible.
4.7.5.5.1 Conguration
In this menu item (under Setup), the scale and interface parameters of the xBPI scale
weighing electronics are congured.
- [Weighing parameters], see Chapter 4.7.5.5.1.1.
In this case: Select [Weighing point C] with [xBPI scale] and press the [Setup] soft key.
WP-C R1 Max 29.9kg d= 0.0005kg
00000
+
kg
xBPI scale setup @admin
Reading parameters
read xBPI model...
read xBPI metrologie data...
read xBPI device info...
read xBPI settings...
The xBPI setup menu opens.
WP-C R1 Max 29.9kg d= 0.0005kg
00000
+
kg
xBPI scale setup @admin
Configuration
Select group of specifications
Device information
The parameters are read from the xBPI scale. Ticks indicate the progress.
4 System setup Process Controller Maxxis 5 PR 5900
EN-151 Minebea Intec