MKS 146C - The Various Displays in Tuning Mode

General Information Cha
p
ter Six: O
p
eration in Tunin
g
Mode
154
The Various Displays in Tuning Mode
In Tuning Mode, the content of the different displays varies depending upon which function you
are currently performing. Table 42, page 155, summarizes what is in each display when
performing Tuning Mode functions. Italics are used to indicate which displays have editable
parameters.
For all parameters
except
Valve Position, the parameter name is displayed when the parameter is
editable. For example, the Base parameter is editable when the word
BASE
is displayed, and
the Set Point parameter is editable when the words
SET POINT
are displayed. Refer to
Figure 1, page 21, to refresh your memory of exactly where the parameter names appear in the
front panel window.
The Valve Position parameter is only editable when no other Tuning Mode parameter (
BASE
,
START
,
INTEGRAL
,
PRESET
,
GAIN
,
LEAD
, or
SET POINT
), is displayed,
and
when the Control Mode
parameter
MANUAL
or
HOLD
is displayed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com