How To Unpack the 146 Instrument Cha
ter Two: Installation
24
Boards
All or some of the following boards may have been ordered with your basic 146 unit. Examine
the rear panel of the 146 unit to make sure your unit conforms to your order code. Refer to
Figure 4, page 27, to see how to identify these boards by their connectors on the rear panel.
Also, refer to the explanation of an order form code in Figure 5, page 28. The boards should be
placed within the 146 unit in the same order as they are listed on your order form.
Also on the order form configuration sheet, are specific configuration instructions. For example,
the unit can be set up for a single channel Pirani board (the default is a dual channel board), or
for a low power HPS hot cathode (the default is for a high power gauge).
Labels are placed at each occupied board slot on the rear panel of the 146 unit. The labels
identify the channel number(s) and type of board installed in the slot.
•
Capacitance Manometer Board
•
Dual Pirani/Convection Board
•
Cold Cathode Board
•
Hot Cathode Board
•
Mass Flow Controller Board
•
Auxiliary Output Board
•
Control Board
•
Binary Coded Decimal (BCD) Board
•
Dual Thermocouple Board
Optional Accessories
Refer to
Appendix B: Parts List/Accessories,
page 303
•
Gauges
•
Valves
•
Mass Flow Controllers
•
Cables for Gauges/Valves/Mass Flow Controllers
•
Remote Front Panel with cable
•
Displayless Type 146 Units (indicated as such in the order code)
•
RM-6 Rack Mount (MKS p/n RM6)
•
RS-232 Cable for Displayless Units (MKS p/n CB146-21)
•
Labels for rear panel board identification (MKS p/n LB-1141011)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
