Code 8: How To Edit the Data Logger Interval Cha
ter Seven: O
eration in Setu
Mode
224
Code 8: How To Edit the Data Logger Interval
LEFT DISPLAY
CLOSE
SETUP
CODE
The code number is
displayed and edited here.
In this example, the
code number is 8.
MAIN DISPLAY
The data lo
er interval value is shown here.
The value can ran
e from 1 to 3600.
Figure 72: Code 8 Display
The data logger interval is the time period (from 1 to 3600 seconds), for the periodic output of
pressure readings. The default is 60 seconds. The pressure reading outputs are for all four
channels, and are sent via the RS-232 port. The data logger interval may be selected at any time,
regardless of the currently selected protocol. Refer to
Code 5: How To Configure the
RS-232
Port
,
page 220, to select a protocol.
1. Repeatedly press the [
DISPLAY MODE
] key until the 146 unit is in Setup Mode.
The system responds by scrolling through modes.
2. Use the arrow keys to scroll to the
CODE
legend.
The system responds by causing the left display to blink.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
