MKS 146C - Page 248

Chapter Seven: Operation in Setup Mode Code 8: How To Edit the Data Lo
gg
er Interval
225
3. Enter the number
8
and press the [
ENTER
] key.
The system responds by displaying the appropriate parameters for code 8, and causing
the main display to blink.
4. Enter the value for the data logger interval (1 through 3600 seconds, inclusive).
A. If the display is correct, press the [
ENTER
] key.
B. If the display is not correct, use the numeral keys to enter a value between 1 and
3600, then press the [
ENTER
] key.
The system responds by accepting the data logger interval value.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com