Code 1: How To Select Pressure/Volt/Current Cha
ter Seven: O
eration in Setu
Mode
214
5. If Volt is selected, the right display blinks. Select HU (high voltage for cold cathodes),
IC (ion current for ion gauges), or EC (emission current for hot cathodes).
Note
This parameter is irrelevant if a gauge other than an ion gauge is selected
as the main display channel in Normal or Leakage Modes. Press the
[
ENTER
] key.
A. If the display is correct for an ion gauge, press the [
ENTER
] key.
B. If the display is not correct for an ion gauge, use the [
] and [ ] (arrow keys)
to scroll to the correct selection, then press the [
ENTER
] key.
The system responds by accepting the configuration choice for the main display in
Normal or Leakage Modes.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
