MKS 146C - Page 240

Chapter Seven: Operation in Setup Mode Code 3: How To Ad
j
ust Audio Alarms
217
3. Enter the number
3
and press the [
ENTER
] key.
The system responds by displaying the appropriate parameters for code 3, and causing
the main display to blink.
4. Select On or Off in the main display (the default is On).
A. If the display is correct, press the [
ENTER
] key.
B. If the display is not correct, press either the [
ON
/
LEAD
] (to turn sounds On), or
[
OFF
/
GAIN
] (to turn sounds Off), then press the [
ENTER
] key.
The system responds by turning the alarm audio tone on or off.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com