MKS 146C - Page 242

Chapter Seven: Operation in Setup Mode Code 4: How To Ad
j
ust Al
p
ha (PID Control)
219
3. Enter the number
4
and press the [
ENTER
] key.
The system responds by displaying the appropriate parameters for code 4, and causing
the main display to blink.
4. Enter an appropriate Alpha value, between 5 and 99 (the default is 20).
A. If the display is correct, press the [
ENTER
] key.
B. If the display is not correct, enter the correct value, then press the [
ENTER
] key.
The system responds by accepting the Alpha value.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com