Chapter Nine: RS-232 Communications Command Messa
es
275
How To Select the Response Format
You can specify whether the response sent by the 146 unit is in scientific notation or fixed
format. The initial configuration is fixed. The 146 unit will
accept
messages in either format,
regardless of the format selected for its response messages. To configure the 146 unit to respond
in scientific notation, issue the command:
@508
•
:E<CR>
where
•
= represents a blank space
E = for scientific notation (D selects fixed notation)
Note
You must re-issue this command after each power up since it is
not stored
at power down.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page