Call Control
3-18 AT Commands Reference Manual December 31, 2007
Example
RING//Incoming call
RING //Incoming call
ath //Hang-up incoming call
NO CARRIER
OK //Incoming call has been terminated - user determined user busy
RING
ata
OK //Voice call connected
ath //Hang-up connected call
NO CARRIER
OK //Active call has been hung-up - terminated
(... Active multi party call, with 3 numbers …)
ath
NO CARRIER
NO CARRIER
NO CARRIER
OK
atd035659260;
OK
ath //Terminate MO voice call while placed
NO CARRIER
OK
Example - Hanging up a data call:
atd035659260
CONNECT//Data call connected - Online Data mode
…
+++ //ESC Sequence is sent from the terminal to the G24
OK //The G24 is in Command mode
ath //Terminate Data call
NO CARRIER
OK
Single Active and Waiting Call Single Active released (waiting not affected)
MTPY Active and Waiting Call MTPY Active released (waiting not affected)
Single Held or MTPY Held Error 3
Single (or MTPY) Active and Single (or
MTPY) Held
Single (or MTPY) Active released
Held (Single or MTPY) and Waiting Call Waiting call released
Single (or MTPY) Active and Single (or
MTPY) Held & Waiting call
Single (or MTPY) Active released
Call State Response/Action
To Next Page
Loading...
Need help?
General
