Motorola G24 Guide - MFOTAABORT, Abort the DM Session; MFOTAINSTL, Install the FOTA Updated Package

Firmware Update Over the Air (FOTA)
3-270 AT Commands Reference Manual December 31, 2007
+MFOTAINSTL, Install the FOTA Updated Package
Install the updated package if the conditions are met:
If update package was downloaded and OMA state is "Ready to update" then the module will
start update installation, otherwise, the module will reply with CME error: "operation not
allowed".
This command is a basic command.
In MUX mode, this AT command is allowed on DLC2 only.
+MFOTAABORT, Abort the DM Session
This command enables to abort the DM session. As a result, the FOTA activities above DM
session (interaction with the server and download) are stopped.
This command is a basic command.
In MUX mode, this AT command is allowed on DLC2 only.
Example
+MFOTAREQ: 2 // Download request
AT+MFOTARSP=0 // Confirm the download operation
OK
+MFOTAIND: 10, 4
+MFOTAIND: 10, 5 // DM Session in progress
+MFOTAIND: 10, 7 // DM Session complete
+MFOTAIND: 16, 14 // Download in progress
+MFOTAIND: 16, 13, 0 // Progress bar indication
+MFOTAIND: 16, 13, 5 // Progress bar indication
AT +MFOTAABORT // Abort download
OK
Command
Type
Syntax Response/Action Remarks
Execute
AT+MFOTAINSTL OK
or:
+CME ERROR<err>
Install the updated package.
Command
Type
Syntax Response/Action Remarks
Execute
+MFOTAABORT OK
or:
+CME ERROR<err>
The Execute command aborts
the DM session.
OK is returned.