Call Control
3-46 AT Commands Reference Manual December 31, 2007
OK
AT+MTTY?
+MTTY: 1
OK
Call Status Messages
+CPAS, Phone Activity Status
This command displays the current activity status of the G24, for example, call in progress, or
ringing.
The following table shows the +CPAS parameters.
Example
AT+CPAS
+CPAS: 0
OK
AT+CPAS=?
+CPAS: (0,2-4)
OK
AT+CPAS?
Command Type Syntax Response/Action Remarks
Execute/Read
AT+CPAS
AT+CPAS?
OK
or:
+CME ERROR: <err>
The Execute and Read commands
return the acti
vity status <pas> of
the
G24. They can be used to interrogate
the G24.
Test
AT+CPAS=? +CPAS: (list of
supported <pas>s)
OK
or:
+CME ERROR: <err>
Table 3-21: +CPAS Parameters
<Parameter> Description
<pas> 0 - Ready - The G24 allows commands from the terminal
2 - Unknown - The G24 is not guaranteed to respond to instructions
3 - Ringing (MT calls) - The G24 is ready for commands from the terminal, but the
ringer is active
4 - Call in progress - The G24 is ready for commands from the terminal, but a call is
in progress
To Next Page
Loading...
Need help?
General
