UI (User Interface)
3-322 AT Commands Reference Manual December 31, 2007
+MUPB, Phone Book Event
This output is sent by the G24 when a phone book entry is accessed or modified.
Unsolicited Report
+MUPB: <event>,<ind
ex>,<ph_list>
The following table shows the +MUPB parameters.
Example
AT+MUPB=1
OK
+MUPB: 2,4."ME"//User modifies location 4
6 SIM Pin 1 requested 0/1 0 SIM pin ready
1 SIM pin required
7 SIM SMS full 0/1 0 SIM SMS storage is not full
1 SIM SMS storage is full
8 GPRS coverage 0-2 0 No GPRS coverage
1 GPRS coverage
2 EDGE coverage
Note:
GPRS/EDGE coverage will be
detected only when SIM has GPRS
ability.
12 SIM insertion/removal
indication
0/1 0 SIM card removed from phone
1 SIM card inserted into phone
Command Type Syntax Response/Action
Set
+MUPB=<n> OK
Table 3-213: +MUPB Parameters
<Parameter> Description
<n> 0 Event reporting Off
1 Event reporting On
<event> The type of operation performed on the location
1 Stored (new)
2 Modified
3Cleared
<index> Location number of the accessed entry
<ph_list> Phone list affected by the change
Table 3-212: +CIEV Parameters (Cont.)
<ind> Description <value> Range Explanation
To Next Page
Loading...
Need help?
General
