Motorola G24 Guide - CRLP, Radio Link Protocol

Network
3-168 AT Commands Reference Manual December 31, 2007
+CRLP, Radio Link Protocol
This command displays the Radio Link Protocol parameters that are used when non-transparent
data calls are originated.
The following table shows the +CRLP parameters.
Example
AT+CRLP=?
+CRLP: (010-061),(010-061),(048-255),(006-010)
OK
AT+CRLP?
+CRLP: 061,061,048,006
OK
Command
Type Syntax Response/Action Remarks
Set
+CRLP=
[<iws>[,<mws>[,<T1>
[,<N2>]]]]
OK
or:
+CME ERROR: <err>
The Set command enables
you to change the RLP
parameters.
Read
+CRLP? +CRLP= <iws>,<mws>,<T1>,<N2>
OK
or:
+CME ERROR: <err>
Test
+CRLP=? +CRLP= (list of supported <iws>s),
(list of supported <mws>s), (list of
supported <T1>s), (list of supported
<N2>s)
OK
or:
+CME ERROR: <err>
Table 3-101: +CRLP Parameters
<Parameter> Description
<iws> IWF to MS window size.
The default value is 61.
<mws> MS to IWF window size.
The default value is 61.
<T1> Acknowledgement timer T1.
The default value is 48.
<N2> Retransmission attempts N2 in integer format (refer to GSM 04.22 [18] subclause
5.4.3)
The default value is 6.