Motorola G24 Guide - General Audio Commands; MADIGITAL, Analog;Digital Audio Switching

Audio
3-244 AT Commands Reference Manual December 31, 2007
General Audio Commands
+MADIGITAL, Analog/Digital Audio Switching
This command switches between analog and digital audio modes. AT+MADIGITAL=1 switches
to digital audio mode, and AT+MADIGITAL=0 switches it back to analog mode.
The following table shows the +MADIGITAL parameters.
Example
AT+MADIGITAL=?
+MADIGITAL: (0,1)
OK
AT+MADIGITAL?
+MADIGITAL: 0
OK
AT+MADIGITAL=1
OK
AT+MADIGITAL?
+MADIGITAL: 1
OK
AT+MADIGITAL=0
OK
AT+MADIGITAL?
+MADIGITAL: 0
OK
AT+MADIGITAL=3
ERROR
AT+MADIGITAL?
+MADIGITAL: 0
OK
Command
Type
Syntax Response/Action Remarks
Set
+MADIGITAL=
<mode>
OK
or:
+CME ERROR: <err>
The Set command toggles between analog
and digital audio modes.
Read
+MADIGITAL? +MADIGITAL:<mode>
OK
The Read command returns the current
audio mode (analog or digital).
Test
+MADIGITAL=? +MADIGITAL:
<available audio modes>
OK
The test command returns the available
digital audio modes.
Table 3-160: +MADIGITAL Parameters
<Parameter> Description
<mode> 0 G24 works in analog audio mode.
1 G24 works in digital audio mode.