GPRS/EDGE
3-334 AT Commands Reference Manual December 31, 2007
+CGPRS, GPRS Coverage
This command indicates whether there is GPRS coverage.
Note: GPRS/EDGE coverage will be detected only when SIM has GPRS ability.
The following table shows the +GPRS parameters.
Example
Without GPRS coverage
AT+CGPRS
+CGPRS: 0
OK
AT+CGPRS?
+CGPRS: 0
OK
With GPRS coverage
AT+CGPRS
+CGPRS: 1
OK
Command Type Syntax Response/Action Remarks
Execute
AT+CGPRS +CGPRS: <mode>
OK
or:
+CME ERROR: <err>
The Execute command returns the
mode of the GPRS coverage.
Read
AT+CGPRS? +CGPRS: <mode>
OK
or:
+CME ERROR: <err>
The Read command returns the mode
of the GPRS coverage
Table 3-220: +GPRS Parameters
<Parameter> Description
<mode> 0 No GPRS coverage
1 GPRS coverage
2 EDGE coverage
There is no parameter default value
To Next Page
Loading...
