Motorola G24 Guide User Manual

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-403
MIPCONF - Configure Internal TCP/IP stack
This command allows to configure TCP stack parameters, such as retransmissions number, upper
and bottom limits of retransmission timeout, close delay. It can be used to configure TCP socket
parameters before socket activation or when the socket is in active state. Configuration values
will be stored in G24 until power circle.
Command Type Syntax Response/Action Remarks
Set
AT+MIPCONF=<
socket>[,[<retr_n
um>],[<min_TO>
],[<max_TO>],[<
max_close_delay>
][,<is_nack_ind_r
eq>]]
OK
or:
+CME ERROR: <err>
The Set updates TCP
stack configuration
parameters.
Read
+MIPCONF? +MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
he read command
returns current
settings of TCP stack
parameters.
Test
+MIPCONF=? +MIPCONF:
(1-4),(1-5),(1-10),(10-600),(1-75),(0-2)
The Test command
returns the possible
parameters values.
Time values can be
inserted with
resolution of 100
milliseconds.
Table 3-272: +MIPCONF Parameters
Parameter Description
< socket > Number of configured TCP socket (1 to 4)
< retr_num > Number of retransmissions (1 to 5)
< min_TO > Bottom limit to retransmit timeout (100 ms to 1 sec.)
<max_TO> Upper limit to retransmit timeout (1 sec. to 60 sec.)

Motorola G24 Guide Specifications

General

Brand	Motorola
Model	G24 Guide
Category	Telephone Accessories
Language	English