Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-271
+ MFOTAIND, Send Unsolicited FOTA Indications Toward
the DTE
When set, the module will send all the indications mentioned in Table 3-179.
By default, FOTA unsolicited information report is Disabled.
This command is a basic command.
In MUX mode, this AT command is allowed on DLC2 only.
The following table shows the +MFOTIND parameters.
Command
Type Syntax Response/Action Remarks
Set
AT+MFOTAIND=
<EN-ind>
OK
or:
+CME ERROR:<err>
The Set command
enables/disables Unsolicited
indications. See Table 3-179.
Read
AT+MFOTAIND? + MFOTAIND:
< EN-ind >,
OK
Returns <EN-ind> value.
Test
AT+FOTAIND=? + FOTAIND:
(list of < EN-ind >s)
Unsolicited
Report
+FOTAIND +FOTAIND: <OMA
state>,
<FOTA-Indication>
OMA state and FOTA information
reports during FOTA process.
Table 3-179: +MFOTAIND Parameters
<Parameter> Description
<EN-ind> 0 - Disable FOTA unsolicited informational report.
1 - Enable FOTA unsolicited informational report.
The default value is 0.
Enables the Module to indicate the DTE with FOTA progress. Relevant to Non
transparent mode.
To Next Page
Loading...
