Data Call
4-18 AT Commands Reference Manual December 31, 2007
Data Call
Switching Modes (Data Mode/Command Mode)
atd054565190 //Calling the remote modem
OK
aaaaaaaaaaaaa //Receiving binary data from remote side (G24 is in Data mode)
//Sending escape sequence +++ to G24 (the remote side does not treat +++ as escape)
OK //G24 is in Command mode
ati3 //Issuing an AT command
Motorola Mobile Phone
OK
ato //Switching back to Binary mode
OK
fffffff //Receiving binary data from remote side
fghhgatfhgfhfhghhfhfhfhgfhffhgfgfhgfhgfhhh
//Sending escape sequence +++ to the G24
ath //Hang up the CSD call (return to Command mode)
OK
NO CARRIER
To Next Page
Loading...
