Motorola G24 Guide - MCST, Call Status Messages

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-49
+CLCC: 0
OK
AT+CLCC=1//Example with unsolicited indication
OK
ATD055490698;
OK
+CLCC: 1,0,2,0,0,"055490698",129,"Alpha"
+CLCC: 1,0,3,0,0,"055490698",129," Alpha "
OK
+CLCC: 1,0,0,0,0,"055490698",129," Alpha "
ATH
NO CARRIER
OK
+CLCC: 1,0,6,0,0,"055490698",129," Alpha
+MCST, Call Status Messages
This command displays the current state of the call processing, and also enables/disables the
unsolicited indication of any change in the call processing state.
+MCST Indication
When a change in call state occurs and the +MCST is set to n=1 the G24 will give the following
indication:
+MCST: <state>
Command Type Syntax Response/Action Remarks
Set
+MCST=<n> OK
or:
+CME ERROR: <err>
The Set command Enables/disables the
unsolicited call status messages.
Read
+MCST? +MCST: <state>
OK
The Read command returns the current
call processing state.