Motorola G24 Guide - MFOTARSP, Respond to +MFOTAREQ Report

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-269
+MFOTAREQ: 3 // Request to Upgrade Phone Software
AT+MFOTAREQ
+MFOTAREQ: 3
AT+MFOTARSP=2 // Postpone the Upgrade operation
OK
+MFOTARSP, Respond to +MFOTAREQ Report
This command is used to send a response to +MFOTAREQ reports.
This command is a basic command.
In MUX mode, this AT command is allowed on DLC2 only.
The following table shows the +MFOTARSP parameters.
Example
+MFOTAREQ: 1 // Request to begin DM session
AT+MFOTARSP=0 // Confirm DM session beginning
OK
+MFOTAREQ: 2 // Request to start downloading an Update-Package
AT+MFOTARSP=1 // Reject the download operation
OK
+MFOTAREQ: 3 // Request to Upgrade Phone Software
AT+MFOTARSP=2 // Postpone the Upgrade operation
OK
Command
Type Syntax Response/Action Remarks
Set
AT+ MFOTARSP =
<action>
<OK>
or:
+CME ERROR:
Test
AT+ MFOTARSP=? + MFOTARSP: (list of <
action>s)
Table 3-178: +MFOTARSP Parameters
<Parameter> Description Remarks
<action> 0 - start
1 - reject
2- one hour postpone
2 - relevant for upgrade
operation only.