Motorola G24 Guide - MEMSE, Send Email Message

Email
3-156 AT Commands Reference Manual December 31, 2007
+MEMSE, Send Email Message
This AT command is used to connect to mail server in order to Send the email massages to the
G24 memory. In case the <notification> parameter is set to ON, the unsolicited message will be
printed to the TE with connection status.
The following table shows the +MEMSE parameters.
Command
Type
Syntax Response/Action Remarks
Set
AT+MEMSE=<message_id>
[,notification>]
OK
Or:
+CME ERROR: <err>
Unsolicited
Report
+MEMSE: <status>
In case of active unsolicited
report (notification equals
to `1`).
Test
AT+MEMSE=? +MEMSE: (list of
supported <notification>
values)
Table 3-94: +MEMSE Parameters
<Parameter> Description
<notification> 0 - Unsolicited report for sending status is disabled.
1 - Unsolicited report for sending status is enabled.
The default value is 0.
<message_id> Integer type - Message identifier number to send.
<status> Integer value. Notification for the receiving status.
See Table 3-95.