Motorola G24 Guide - Page 239

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-155
The following table shows the +MEMDE parameters.
Example:
AT+MEMDE=0
OK
NO CARRIER// GPRS connection is closed at the end of process
AT+MEMDE=1
+MEMDE: 0
+MEMDE: 2
+MEMDE: 3
+MEMDE: 5
+MEMDE: 6
+MEMDE: 8
+MEMDE: 14
+MEMDE: 13
+MEMDE: 16
+MEMDE: 26
+MEMDE: 17
+MEMDE: 14
+MEMDE: 13
+MEMDE: 16
+MEMDE: 26
+MEMDE: 17
+MEMDE: 21
+MEMDE: 22
+MEMDE: 1
OK
NO CARRIER
Execute
AT+MEMDE OK
Or:
+CME ERROR: <err>
Execute command acts as
set command with
notification equals to `0`.
Table 3-93: +MEMDE Parameters
<Parameter> Description
<notification> 0 - Unsolicited report for receiving status is disabled.
1 - Unsolicited report for receiving status is enabled.
The default value is 0.
<status> Integer value. Notification for the receiving status.
See Table 3-95.
Command
Type
Syntax Response/Action Remarks