Network
3-190 AT Commands Reference Manual December 31, 2007
+MCI, Motorola Cell Information
This command returns neighbor cell information.
Command
Type
Syntax Response/Action Remarks
Set
Execute
AT+MCI=[<Filter>]
[,<enable_TA>]
Or
AT+MCI
+MCI: <serving cell
ARFCN>,<serving cell
BSIC>,<signal
strength>[,<TA>]
[,<neighbor 1
ARFCN>,[<neighbor 1
BSIC>],<signal
strength>
[,<neighbor 2
ARFCN>,[<neighbor 2
BSIC>],<signal
strength>
[,<neighbor 3
ARFCN>,[<neighbor 3
BSIC>],<signal
strength>
[,<neighbor 4
ARFCN>,[<neighbor 4
BSIC>],<signal
strength>
[,<neighbor 5
ARFCN>,[<neighbor 5
BSIC>],<signal
strength>
[,<neighbor 6
ARFCN>,[<neighbor 6
BSIC>],<signal
strength>]]]]]]
OK
+MCI (Motorola Cell Information)
command returns ARFCN, BSIC and
RX level of serving and adjacent
cells. In case G24 is registered,
adjacent cells are from registered
PLMN. In case G24 is in Emergency
Mode, adjacent cells are physical
neighbors. BSIC is displayed only in
case SCH (Synchronization Channel)
is decoded.
The parameter <enable_TA>
determines whether <TA> will be
reported by +MCI command. <TA> is
defined for serving cell only. This
value will be displayed only in
Dedicated mode.
The command output is <Filter>
dependent. In case the command
output should be filtered to include
just cells of a specific GSM band (one
or more) the filter parameter should
be set accordingly,
see Table 3-123. The filtering will
apply to the neighbor's cells only - the
serving cell info will always be
returned.
Using the set command without a
parameter will return output
according to the currently set <Filter>
value.
Read
AT+MCI? +MCI: <Filter>,
<enable_TA>
OK
The Read command returns the current
set <Filter> and <enable_TA> values.
Test
AT+MCI=? +MCI: (List of
supported <Filter>s),
(Range of supported
<enable TA>s)
OK
The Test command returns the ranges
of <Filter>'s supported values and
<enable TA> supported values.
To Next Page
Loading...
Need help?
General
