Motorola G24 Guide - CALM, Alert Sound Mode

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-245
+CALM, Alert Sound Mode
This command handles the selection of the G24's alert sound mode. The value of the command is
saved after a power cycle.
The following table shows the +CALM parameters.
Note: Selecting the ring mode with this command retrieves the current alert volume level
setting.
Example
AT+CALM=?
+CALM: (0,1)
OK
AT+CALM?
+CALM: 0
OK
AT+CALM=1
OK
Command Type Syntax Response/Action Remarks
Set
+CALM=<mode> OK
+CME ERROR: <err>
The Set command sets the alert sound
mode.
Read
+CALM? +CALM: <mode>
+CME ERROR: <err>
The Read command displays the
current alert sound mode setting.
Test
+CALM=? +CALM: (list of
supported <mode>s)
+CME ERROR: <err>
The Test command displays the list of
supported modes.
Table 3-161: +CALM Parameters
<Parameter> Description
<mode> Alert sound mode of the G24.
0Ring (default)
1 Silent mode (ring prevented)