Motorola G24 Guide - MHDPB, Motorola Headset Dual-Position Button

UI (User Interface)
3-318 AT Commands Reference Manual December 31, 2007
+MHDPB, Motorola Headset Dual-position Button
This command is used to enable and disable the SEND/END functionality of the headset
dual-position button.
The following table shows the +MHDPB parameters.
Example
AT+MHDPB=0
OK
atd44345678;
OK
>Long press on the headset dual-position button:
NO CARRIER > The call is released.
>Call to the unit:
RING
RING
>Short Press on the headset dual-position button:
OK > The unit is answering the incoming call
>Long press on the headset dual-position button:
NO CARRIER > The call is released.
AT+MHDPB=1
Command
Type
Syntax Response/Action Remarks
Set
AT+MHDPB=<mo
de>
OK
or:
+CME ERROR: <err>
Read
AT+MHDPB? +MHDPB=<mode>
OK
or:
+CME ERROR: <err>
Test
AT+MHDPB=? +MHDP: possible value of <mode>
OK
Table 3-209: +MHDPB Parameters
<Parameter> Description
<mode> Enable or disable the headset dual-position button functionality.
0 Enable the headset dual-position button functionality. The short press
on headset button will emulate short SEND and long will emulate short END.
This is a default value.
1 Disable the headset dual-position button functionality.
The headset dual-position button will take no effect.