December 31, 2007 AT Commands Reference Manual A-1
Appendix A: Reference Tables
This appendix contains the following sections:
• AT Commands Alphabetical Summary, below
• AT Commands Behaviour With UART2 Fully Functional, Page -22
• Character Set Table CS1: (GSM -> UCS-2), Page -31
• Character Set Table CS2: (ASCII <-> UTF-8), Page -35
• Character Set Table CS3: (UCS-2 <-> UTF-8), Page -35
• Character Set Table CS6: (UCS-2 Full Table), Page -35
• Character Set Table CS7: (ASCII table), Page -35
Note: Character Set Table CS6: (UCS-2) is provided on CD due to its size.
AT Commands Alphabetical Summary
The following table contains an alphabetical list of all the G24 AT commands.
Table A-1: AT Commands (Alphabetical)
AT Command Description Page
$
This command displays a list of
all the AT commands supported
by the G24.
Page 3-8
%C
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&C
This command determines how
the state of the DCD line relates
to the detection of the received
line signal from the distant end.
Page 3-199
&D
This command determines how
the G24 responds when the DTR
(Data Terminal Ready) status is
changed from ON to OFF during
the online data state.
Page 3-201
&F
This command restores the
factory default configuration
profile.
Page 3-281
To Next Page
Loading...
