Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-51
+MCST: 3
+MCST: 17
NO CARRIER
+MCST: 1
+TCLCC, List Current Calls
This command displays a list of all current G24 calls and their statuses, and also enables/disables
the unsolicited indication of the call list.
This command is operational only with specific Telematics products.
Operation of this command is flex dependant.
Command
Type
Syntax Response/Action Remarks
Set
AT+TCLCC=<state> OK
or:
+CME ERROR: <err>
Set unsolicited reporting on/off.
Read
AT+TCLCC? +TCLCC:<state>
or:
+CME ERROE:<err>
Read the current setting.
Execute
AT+TCLCC +TCLCC:
<idx>,<dir>,<callstate>
,<mode>,<mpty>,[<exit
cause>]
[,<number>,<type>][<
CR><LF>+TCLCC:
<idx>,<dir>,<callstate>
,<mode>,<mpty>,[<exit
cause>]
[,<number>,<type>][…
]]
OK
or:
+CME ERROE:<err>
Read the current call status.
Test
AT+TCLCC=? +TCLCC: (List of
supported<state>s)
OK
or:
+CME ERROE:<err>
Show list of supported modes.
To Next Page
Loading...
