Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-277
S, Bit Map Registers
This command reads/writes values of the S-registers. The G24 supports this command for various
S values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
Command Type Syntax Response/Action Remarks
Set
ATSn=<value OK
or:
+CME ERROR: <err>
The Set command is allowed for
read/write S-registers, and not allowed
for read-only S-registers.
Read
ATSn? <current value of
S-register n>
or:
+CME ERROR: <err>
Test The Test command for Sn is not
defined by ITU, and therefore is not
supported by the G24. The G24 returns
an error.
To Next Page
Loading...
