Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-91
Example
AT+MDBR=1,10
+MDBR:3,"13:30","07/02/15","Weekly Meeting",1,2,"3,4"
OK
AT+MDBR=?
+MDBR:500,1,64,8,2
OK
+MDBW, Write Date Book Entry
This command enables the user to store a new entry in the date book, or edit an existing entry
from the date book. A particular entry in the date book can be stored, or the next available entry is
used. The entry is selected by <index>, the time and date are entered into the <Time> and <Date>
fields. If these fields are omitted or set to past time, CME ERROR: <err> is returned. If the
<index> field is omitted, but time and date are entered in the <Time> and <Date> fields, the entry
is entered into the first available entry in the date book. If the writing fails in a G24 error, +CME
ERROR: <err> is returned.
The phone book and date book are share dynamic memory storage. If the writing fail in a G24
error in case of "full memory" error while the memory is not full by 'used' field of +MDBR
command (Refer to “+MDBR, Read Date Book Entries” on page 3-89). It is recommended
checking the memory's capacity of the dynamic memory storage by +MPDPM command (Refer
to “+MPDPM, Motorola Phonebook Dynamic Percentage Memory” on page 3-85).
Exceptions A list of exception instance numbers for the requested
entry.
Numbers in 0-65534 range.
Entries Total number of date book.
Used Number of entries currently used.
tLength The maximum number of characters in the <Title>
entry.
mException The maximum number of exceptions.
Actions The maximum number of actions.
Table 3-47: +MDBR Parameters
<Parameter> Description
To Next Page
Loading...
