Motorola G24 Guide - MTKE, Motorola Toolkit Enable

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-367
Note: The bits comprising each subsequent byte are all: RFU, bit = 0.
+MTKE, Motorola ToolKit Enable
This command enables/disables the SIM ToolKit functionality.
The following table shows the +MTKE parameters.
Table 3-248:
Profile Structure – Byte 19 (Reserved for TIA/EIA-136 facilities)
Bit Description
b1 Protocol Version, coded as indicated in TIA/EIA-136-123
b2
b3
b4
b5 RFU, bit = 0
b6
b7
b8
Command Type Syntax Response/Action Remarks
Set
+MTKE=<Enable> OK
or:
+CME ERROR: <err>
The Set command tells
the G24 in which mode to
work.
Read
+MTKE? +MTKE: <State>
The Read command
returns the current values.
Test
+MTKE=? +MTKE: (list of supported
<state>s)
OK
The Test command
returns the supported
values as a compound
value.
Table 3-249: +MTKE Parameters
<Parameter> Description
<State> Indicates the state of the SIM ToolKit:
0 Deactivate the SIM ToolKit functionality
1 Activate the SIM ToolKit functionality
The default is 0.