Chapter 2: Introduction to AT Commands
December 31, 2007 AT Commands Reference Manual 2-9
Core AT Commands
The G24 responds to a limited commands set when the SIM card is not functioning, or not
present. These commands are referred to as the "Core AT commands".
In previous products, the Core AT commands were called "Basic AT commands". The name
"Core" differentiates between the basic AT commands format and the limited service AT
commands.
The following table lists the Core AT commands.
Table 2-1: Core AT Commands
AT Command Description Page
$ This command displays a list of all the AT commands supported by
the G24.
Page 3-8
%C This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&C This command determines how the state of the DCD line relates to
the detection of the received line signal from the distant end.
Page 3-199
&D This command determines how the G24 responds when the DTR
(Data Terminal Ready) status is changed from ON to OFF during
the online data state.
Page 3-201
&F This command restores the factory default configuration profile.
Page 3-281
&G This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&J This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&K This command configures the RTS/CTS flow control.
Page 3-198
&L This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&M This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&P This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&Q This command selects the asynchronous mode, and has no effect.
Page 3-35
&R This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&S This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&T This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&V This command displays the current active configuration and stored
user profiles.
Page 3-307
&W This command stores the user profile.
Page 3-308
To Next Page
Loading...
