Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-315
+CLAN, ME Language
This command handles the selection of language in the ME.
The <code> parameter is a two-letter abbreviation of the language. The language codes, as
defined in ISO 639, consist of two characters, e.g. "DE", "EN" etc.
The following table shows the +CLAN parameters.
<ind> 0 No indicator events reporting.
1 Indicator event +CIEV: <ind>,<value>.
<ind> shows the indicator order number and <value> is new value of indicator.
The default value is 0.
<bfr> Controls the effect on buffered codes.
0 Clear buffer.
Command
Type
Syntax Response/Action Remarks
Set
AT+CLAN=<code> OK
or:
ERROR
Set command sets the
selected language.
Read
AT+CLAN? +CLAN: <code>
The read command displays
the currently selected lan-
guage.
Test
AT+CLAN=? +CLAN: (list of <code>s)
Test command displays list of
supported language <code>s.
Table 3-207: +CLAN Parameters
<code> Description
DE German
EN English
IT Italian
FR French
ES Spanish
NL Dutch
SW Swedish
DA Danish
PT Portuguese
Table 3-206: +CMER Parameters (Cont.)
<Parameter> Description
To Next Page
Loading...
