Motorola G24 Guide User Manual

GPRS/EDGE
3-356 AT Commands Reference Manual December 31, 2007
+MCEG, Motorola Control EGPRS
This AT command is used to enable or disable EGPRS support in G24 modules with EDGE
support capability.
The command works only in G24 customer models with EDGE capability. The phone restarts 10
seconds after the SET command execution completed. The changes take effect after restart.
The following table shows the +MCEG parameters.
Example
AT+MCEG=?
+MCEG: (0-1)
OK
AT+MCEG=0
OK
AT+MCEG?
+MCEG: 0
OK
AT+MCEG=1
OK
AT+MCEG?
+MCEG: 1
OK
Command
Type Syntax Response/Action Remarks
Set
AT+MCEG=<n> OK
or:
+CME ERROR: <err>
The SET command used
for setting the current
EGPRS support state.
Read
AT+MCEG? + MCEG : <n>
OK
or:
+CME ERROR: <err>
The READ command
returns the current
EGPRS support state
<n>.
Test
AT+MCEG=? + MCEG : (0-1)
OK
or:
+CME ERROR: <err>
The Test command
returns the possible
values' range.
Table 3-227: +MCEG Parameters
<Parameter> Description
<n> Indicates the EGPRS support state (enabled or disabled)
0 Disable EDGE support.
1 Enable EDGE support.

Motorola G24 Guide Specifications

General

Brand	Motorola
Model	G24 Guide
Category	Telephone Accessories
Language	English