Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-163
Example:
AT+MEMR=109
+MEMR:0,"nir@motorola.com","nir@mail.com","mike@mail.com","","","04/30/07 14:28 +02","body
of a read email message"
OK
+MEMD, Delete Email Message
This AT command is used to delete a single message or all the messages in the folder, or to delete
all the massages in all the folders.
<bcc> Addresses of intended copy recipients of current email message. The maximum
length of this parameter is 250 characters.
<subject> The subject of the current email messages. The maximum length of this parameter is
128 characters.
<date> Information about date and time of message receiving by email server. The date
format is: "MM/DD/YY HH:MM: +-Z". Where MM - 2-digit month, YY - 2-digit
year, DD - 2-digit day of month, HH - 2-digit hour, MM - 2-digit minute, Z -
(optional) time zone offset from Greenwich Mean Time. When email is in Draft or
Outbox then it is no GMT time is printing.
<body> The content of the message. The maximum length of this parameter is 3000
characters.
<priority> Specifying the email message priority.
<name_of_atta
chments>
Name of files that attached to the current email message. In case it is more then one
attachment files, those names are separated by a semicolon (;).
Command
Type
Syntax Response/Action Remarks
Set
AT+MEMD=<delflag>[,<tar
get>]
OK
Or:
+CME ERROR: <err>
<target> field can function
as <message_id> or
<folder_id> field depend on
<delflag> value.
Test
AT+MEMD=? MEMD: (list of supported
<delflag> values)
Table 3-97: +MEMR Parameters (Cont.)
<Parameter> Description
<priority>
value
Description
0Urgent
1 Normal
To Next Page
Loading...
