Motorola G24 Guide User Manual

Fax Class 1
3-432 AT Commands Reference Manual December 31, 2007
+FPR, Fax Serial Port Rate
This command sets the request baud rate. +FPR command is implemented as additional syntax to
the standard +IPR command in order to inter-work with existing Facsimile DTE.
The following table shows the +FPR parameter.
Command Type Syntax Response/Action Remarks
Set
+FPR=<n> OK
or:
+CME ERROR: <err>
The set command changes the baud
rate of G24 to the requested value. The
specified rate takes effect following
the issuing of any result code(s)
associated with the current command
line.
The UART is configured to the
specific requested baud rate.
Read
+ FPR? +FPR: <n>
OK
Or
+FPR:255
OK
The read command returns the actual
baud rate. The Report 255 is output in
cases where setting baud rate is not
supported by FPR command.
Test
+ FPR=? +FPR: (list of
supported <n>s)
OK
or:
+CME ERROR: <err>
The test command returns the possible
ranges of <n>s.
Table 3-288: +FPR Parameter
<Parameter> Description
<n> 0 Automatic baudrate
1 Set baudrate to 2400
2 Set baudrate to 4800
4 Set baudrate to 9600
8 Set baudrate to 19200
10 Set baudrate to 38400
18 Set baudrate to 57600
20 Set baudrate to 115200

Motorola G24 Guide Specifications

General

Brand	Motorola
Model	G24 Guide
Category	Telephone Accessories
Language	English