GPRS/EDGE
3-338 AT Commands Reference Manual December 31, 2007
Operation of this command is flex dependant.
Note: Testing of the local connection feature can be done using a Windows dialer. To allow this,
the command ATD*98# can be used instead of AT+MDLC, for testing purpose only.
Example
AT+MDLC
CONNECT
NO CARRIER
+MIAU, IP Addresses Utility
This command is intended for use in applications utilizing the IP Director feature.
This command is used to set/read the IP addresses for the User MIDlet (UM) and external CPU,
and the port number used by UM for local listen socket.
The set values will be persistent and maintained across power cycles.
Note: See G24 KJAVA User’s Guide (P/N 6802981C50) for additional information regarding
IP Director feature.
Operation of this command is flex dependant.
Command
Type Syntax Response/Action Remarks
Execute
AT+MDLC OK
or:
ERROR
Command
Type
Syntax Response/Action Remarks
Set
AT+MIAU=[<UM-IP
-address>]
,[<External-CPU-IP-
address>]
,[<UM-Listen-Socket-
Port>]
OK
or:
ERROR
Read
AT+MIAU? +MIAU: <UM-IP-address>,
<External-CPU-IP-address>,
<UM-Listen-Socket-Port>
To Next Page
Loading...
