Motorola G24 Guide - MRICS, Motorola Ring Indicator Configuration for SMS; TSMSRET, Control SMS Sending Retry

SMS
3-142 AT Commands Reference Manual December 31, 2007
+TSMSRET, Control SMS Sending Retry
This command controls the SMS sending retry.
If SMS sending retry is enabled, the ME will retry sending an SMS when the send operation
failed due to network or ME failure. If disabled, no retry will be done.
Operation of this command is flex dependant.
The following table shows the +TSMSRET parameters.
Example
AT+TSMSRET?
+TSMSRET: 1
OK
AT+TSMSRET=0
OK
AT+TSMSRET?
+TSMSRET: 0
OK
AT+TSMSRET=?
+TSMSRET: (0,1)
OK
+MRICS, Motorola Ring Indicator Configuration for SMS
This command allows configuring the behavior of RI line in a case of SMS arrival.
The command setting supports 3 SMS types:
• SMS-DELIVER
• SMS-STATUS-REPORT
• CBM (broadcast message)
Command
Type
Syntax Response/Action Remarks
Set
AT+TSMSRET=<n> OK
or:
ERROR
Read
AT+TSMSRET? +TSMSRET:<n>
Test
AT+TSMSRET=? +TSMSRET: (Supported
<n>s)
Table 3-86: +TSMSRET Parameters
<Parameter> Description
<n> 0 SMS sending retry is disabled.
1 SMS sending retry is enabled (default setting).