Motorola G24 Guide - MGGIND, GSM;GPRS Service Indicator

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-203
+MGGIND, GSM/GPRS Service Indicator
This command configures the service indicator line of pin 49 of the 70 pin connector to be GPRS
or GSM registration indicator.
The IO line (pin 49) function according to the current registration state (in service or not) of the
specific service indicator configuration.
Note: IO line (pin 49) out come depends on +MCWAKE configuration.
The following table shows the +MGGIND parameters.
Example
AT+MGGIND=0
OK
AT+MGGIND?
OK
+MGGIND: 0
AT+MGGIND=1
OK
AT+MGGIND?
+MGGIND: 1
OK
AT+MGGIND=?
+MGGIND: (0-1)
OK
Command Type Syntax Response/Action
Set
AT+MGGIND=<state> OK
or:
+CME ERROR: <err>
Read
AT+ MGGIND ? +MGGIND: <state>
OK
or:
+CME ERROR: <err>
Test
AT+ MGGIND =? +MGGIND: (list of supported
<state>s)
OK
Table 3-132: +MGGIND Parameters
<Parameter> Description
<state> 0 GPRS registration indicator.
1 GSM registration indicator.