Motorola G24 Guide - MIPFLUSH, Flush Data from Buffers

GPRS/EDGE
3-398 AT Commands Reference Manual December 31, 2007
+MIPFLUSH, Flush Data from Buffers
This command causes the G24 to flush (delete) data accumulated in its accumulating buffers.
The following table shows the +MIPFLUSH parameters.
Command Type Syntax Response/Action
Set
+MIPFLUSH = <Socket ID> ERROR
or:
+MIPFLUSH: <Socket ID>
OK
Read
+MIPFLUSH? +MIPFLUSH:[<socket ID>]
Test
+MIPFLUSH=? +MIPFLUSH=(<Socket ID>)
Table 3-267: +MIPFLUSH Parameters
<Parameter> Description
Socket ID 1,2,3,4 - Number of valid sockets